Nursing Elites

1. According to the Law of Universal Gravitation, the gravitational force between two objects is directly proportional to what factor?

• A. the gravitational constant
• B. the distance between them
• C. the product of their masses
• D. the square of the distance between them

Correct answer: C

Rationale: According to the Law of Universal Gravitation, the gravitational force between two objects is directly proportional to the product of their masses. The equation is: F = G × (m₁ × m₂) / r², where F is the gravitational force, G is the gravitational constant, m₁ and m₂ are the masses of the two objects, and r is the distance between them. Choice A is incorrect because the gravitational constant is a constant value. Choice B is incorrect because the distance between the objects affects the strength of the gravitational force inversely proportional to the square of the distance, not directly proportional. Choice D is incorrect as it represents the inverse square law, where the gravitational force decreases with the square of the distance between the objects.

2. A 5-kg block is suspended from a spring, causing the spring to stretch 10 cm from equilibrium. What is the spring constant for this spring?

• A. 4.9 N/cm
• B. 9.8 N/cm
• C. 49 N/cm
• D. 50 N/cm

Correct answer: C

Rationale: The spring constant (k) can be calculated using Hooke's Law formula: F = -kx, where F is the force applied, k is the spring constant, and x is the displacement from equilibrium. In this case, the force applied is equal to the weight of the block, F = mg, where m = mass of the block = 5 kg and g = acceleration due to gravity = 9.8 m/s^2. The displacement x = 10 cm = 0.1 m. Substituting the values, we have: 5 kg * 9.8 m/s^2 = k * 0.1 m. Solving for k gives k = 5 * 9.8 / 0.1 = 49 N/m. Therefore, the spring constant for this spring is 49 N/cm. Choice A (4.9 N/cm) is incorrect because it is one decimal place lower than the correct answer. Choice B (9.8 N/cm) is incorrect as it does not account for the correct calculation based on the given information. Choice D (50 N/cm) is incorrect because it is slightly higher than the accurate value obtained through the calculations.

3. Household alternating current typically has a frequency of 60 Hz. Which statement is true?

• A. The circuit is suitable for lighting 60-watt bulbs.
• B. Circuits in the home may carry a current of 60 amperes.
• C. The expected voltage drop is 60 volts per meter.
• D. Electrons complete a cycle 60 times per second.

Correct answer: D

Rationale: The correct answer is D. Electrons complete a cycle 60 times per second when the frequency of the current is 60 Hz. This frequency indicates that the current changes direction 60 times per second, causing the electrons to complete a full cycle back and forth through the circuit at the same rate. Choice A is incorrect because the power rating of a bulb (in watts) is not directly related to the frequency of the current. Choice B is incorrect as typical household circuits do not carry currents as high as 60 amperes. Choice C is incorrect as the expected voltage drop is not measured in volts per meter for household alternating current circuits.

4. For steady, incompressible flow through a pipe, the mass flow rate (ṁ) is related to the fluid density (ρ), cross-sectional area (A), and average velocity (v) via the continuity equation:

• A. ṁ cannot be determined without additional information
• B. ṁ = ρvA
• C. Bernoulli's principle is solely applicable here
• D. The equation of state for the specific fluid is required

Correct answer: B

Rationale: The continuity equation for steady, incompressible flow states that the mass flow rate is the product of the fluid's density, velocity, and cross-sectional area. Hence, ṁ = ρvA. Choice A is incorrect because the mass flow rate can be determined using the given formula. Choice C is incorrect as Bernoulli's principle does not directly relate to the mass flow rate calculation. Choice D is incorrect as the equation of state is not needed to calculate the mass flow rate in this scenario.

5. Surface tension, γ, is a property of fluids arising from:

• A. Intermolecular forces between fluid molecules
• B. Gravitational attraction
• C. Viscous dissipation
• D. Pressure differentials within the fluid

Correct answer: A

Rationale: Surface tension, represented by symbol γ, is caused by the cohesive forces between molecules in a liquid. These intermolecular forces, such as Van der Waals forces, hydrogen bonding, and dipole-dipole interactions, create a 'skin' at the surface of the liquid, giving rise to the property of surface tension. Gravitational attraction, viscous dissipation, and pressure differentials within the fluid do not directly contribute to surface tension. Therefore, the correct answer is A.

Similar Questions