if a wave has a frequency of 60 hertz which of the following is true

HESI A2

HESI A2 Physics Quizlet

1. If a wave has a frequency of 60 hertz, which of the following is true?

A. It completes one cycle per minute.
B. It measures 60 m from crest to crest.
C. It completes 60 cycles per second.
D. It measures 60 m from crest to trough.

Correct answer: C

Rationale: The frequency of a wave is the number of cycles it completes in one second. A wave with a frequency of 60 hertz completes 60 cycles per second. Therefore, choice C is correct. Choice A is incorrect because a frequency of 60 hertz means 60 cycles per second, not per minute. Choice B is incorrect as the frequency of the wave does not determine the distance from crest to crest. Choice D is also incorrect as the frequency does not relate to the distance from crest to trough.

2. When a dielectric material is inserted between the plates of a charged capacitor, what will happen to the capacitance?

A. Increase
B. Decrease
C. Remain the same
D. Become unpredictable

Correct answer: A

Rationale: When a dielectric material is inserted between the plates of a charged capacitor, the capacitance will increase. This is because the presence of a dielectric material reduces the electric field between the plates, allowing more charge to be stored for a given voltage, thus increasing the capacitance. Choice B is incorrect because adding a dielectric material increases capacitance. Choice C is incorrect because capacitance changes when a dielectric is added. Choice D is incorrect because the effect of a dielectric on capacitance is predictable.

3. What is the primary factor responsible for generating lift on an airplane wing?

A. Propulsion force generated by the engines
B. Buoyant forces acting on the entire aircraft
C. Drag reduction achieved through streamlining
D. Application of Bernoulli's principle to the airfoil's shape

Correct answer: D

Rationale: The primary factor responsible for generating lift on an airplane wing is the application of Bernoulli's principle. This principle states that the air moving over the curved top surface of the wing has to travel faster, leading to reduced pressure above the wing and creating lift. Engines provide thrust for propulsion, not lift. Buoyant forces are more relevant to lighter-than-air aircraft like balloons or airships, not airplanes. While drag reduction through streamlining is important for efficiency, it is not the primary factor in lift generation. Therefore, the correct answer is D.

4. When a gas is compressed isothermally, we can say that:

A. The gas performs work on the surroundings, and its internal energy increases.
B. The gas performs work on the surroundings, and its internal energy decreases.
C. The surroundings perform work on the gas, and its internal energy increases.
D. The surroundings perform work on the gas, and its internal energy decreases.

Correct answer: D

Rationale: When a gas is compressed isothermally, the surroundings perform work on the gas. In this process, since the temperature remains constant (isothermal), the internal energy of the gas does not change. Therefore, the correct answer is that the surroundings perform work on the gas, and its internal energy decreases. Choices A, B, and C are incorrect because they incorrectly describe the direction of work and the change in internal energy during an isothermal compression.

5. In a circuit with three same-size resistors wired in series to a 9-V power supply, producing 1 amp of current, what is the resistance of each resistor?

A. 9 ohms
B. 6 ohms
C. 3 ohms
D. 1 ohm

Correct answer: C

Rationale: In a series circuit, the total resistance is the sum of the individual resistances. With a total voltage of 9 V and a current of 1 A, we can use Ohm's Law (V = I × R) to find the total resistance: Total resistance = 9 V / 1 A = 9 ohms. Since the resistors are identical and wired in series, the total resistance is evenly divided among the three resistors: Resistance of each resistor = 9 ohms / 3 = 3 ohms. Thus, the resistance of each resistor is 3 ohms. Therefore, the correct answer is 3 ohms. Choice A, 9 ohms, is incorrect because this would be the total resistance of all three resistors combined in series. Choice B, 6 ohms, is incorrect as it does not account for the equal distribution of resistance in a series circuit. Choice D, 1 ohm, is incorrect as it is too low for resistors in series with a total resistance of 9 ohms.